Vehicle Data Hub

2013 Jeep Wrangler stability control problems

Owners reported stability control problems in 18 complaints for the 2013 Jeep Wrangler, 2% of the complaints on file.

At a glance

Complaints
18 2% of this year's complaints
Typical mileage
60,000 miles 16 complaints with mileage
Crashes and fires
0 and 0
Injuries and deaths
0 and 0

Source: NHTSA owner complaints

When stability control problems show up

Stability control complaints by mileage, 2013 Jeep Wrangler Complaints by odometer reading in 20,000-mile steps. The median is about 60,000 miles. 0k to 20k miles: 1 complaints 20k to 40k miles: 3 complaints 40k to 60k miles: 4 complaints 60k to 80k miles: 4 complaints 80k to 100k miles: 2 complaints 100k to 120k miles: 1 complaints 120k to 140k miles: 0 complaints 140k to 160k miles: 1 complaints 160k to 180k miles: 0 complaints 180k to 200k miles: 0 complaints 200k+ miles: 0 complaints 040k80k120k160k200k miles Typical: 60,000 miles
Based on 16 complaints that include mileage. 50% were reported before 60,000 miles. The amber marker shows the median: half of these complaints happened before that mileage.
View the numbers
MileageComplaints
0k to 20k miles1
20k to 40k miles3
40k to 60k miles4
60k to 80k miles4
80k to 100k miles2
100k to 120k miles1
120k to 140k miles0
140k to 160k miles1
160k to 180k miles0
180k to 200k miles0
200k+ miles0

What the data shows

Of the 16 stability control complaints that report mileage, the median is about 60,000 miles, and 50% were reported before 60,000 miles.

None of the stability control complaints mention a crash, fire, injury or death.

What owners wrote

2013 jeep wrangler . Consumer writes in regards to vehicle electrical problems. *smd the consumer stated when a tone sounded, the brake light, ABS and stability lights illuminated. Also the speedometer and tachometer needles went to zero, and the cruise control shut off, slowing the vehicle down instantly. The stability and brake switch were replaced.

April 2014

While driving with cruise control engaged on the highway at roughly 80MPH, the cruise control kicks off. Check engine light displays and the ESC light comes on. Vehicle loses power and decelerates on its own. Have to floor the gas pedal to keep the vehicle moving. Experiences momentary bursts of speed but then speed declines again although the gas pedal is still pressed to the floor. I believe this is attributed to the clockspring assembly but my vehicle was not included in the recall.

Reported at 84,000 miles, April 2019

Other problems reported for the 2013 Jeep Wrangler

Stability control problems in other years

  • 2027
  • 2026
  • 2025
  • 2024
  • 2023
  • 2022
  • 2021
  • 2020
  • 2019
  • 2018
  • 2017
  • 2016
  • 2015
  • 2014
  • 2013
  • 2012
  • 2011
  • 2010
  • 2009
  • 2008
  • 2007
  • 2006
  • 2005
  • 2004
  • 2003
  • 2002
  • 2001
  • 2000
  • 1999
  • 1998
  • 1997
  • 1995
  • 1994
  • 1993
  • 1992
  • 1991
  • 1990

Stability control problems across all Jeep models