1994 Buick Century recalls
The 1994 Buick Century is affected by 6 safety recall campaigns in NHTSA's records.
At a glance
- Recall campaigns
- 6
- Most recent
- September 15, 1995
Source: NHTSA recall records
Recall campaigns
| Campaign | Reported | Part | Problem | Vehicles |
|---|---|---|---|---|
| 95V-173 | September 15, 1995 | Seat belts (front, anchorage) | These vehicles were assembled with rear outboard safety belt anchorages that may not withstand the required load. This does not comply with fmvss no.210, "seat belt assembly anchorages." | 2,216,325 |
| 94V-189 | October 4, 1994 | Steering (linkages, knuckle, spindle, arm) | The right hand spindle nut was not properly tightened during assembly. This can cause premature wheel bearing failure and over time, the spindle can fracture. | 206 |
| 94V-159 | August 31, 1994 | Latches/locks/linkages (doors, latch) | Water intrusion can cause a short circuit in the power door lock assembly. | 139,542 |
| 94V-008 | January 12, 1994 | Vehicle speed control (springs) | In the event of a primary accelerator control spring failure, the secondary (back-up) accelerator control return spring will not return the throttle to the fully closed position, as required by fmvss no. 124, "accelerator control system." | 49,047 |
| 94V-021 | January 8, 1994 | Vehicle speed control (cables) | During assembly, water may have entered the accelerator control cable conduit causing it to develop a high effort and/or binding condition in very cold weather. | 10,646 |
| 93V-162 | September 27, 1993 | Vehicle speed control | The cruise control cable may separate from the conduit end fitting while engaged and accelerator control could be lost. | 579 |