1994 GMC C35 recalls
The 1994 GMC C35 is affected by 7 safety recall campaigns in NHTSA's records.
At a glance
- Recall campaigns
- 7
- Most recent
- February 5, 1999
Source: NHTSA recall records
Recall campaigns
| Campaign | Reported | Part | Problem | Vehicles |
|---|---|---|---|---|
| 99V-025 | February 5, 1999 | Exterior lighting (brake lights, switch) | Vehicle description: pickup trucks, crew cabs, utility trucks and sport utility vehicles. These vehicles were built with the polarity of the wiring for the zero adjust brake switch reversed from what was specified on the switch drawing. With the reversed polarity, the contacts in the brake switch can wear out… | 988,587 |
| 95V-246 | December 21, 1995 | Seats | The seat recliner to seat frame attaching bolts on these vehicle could loosen, fatigue and fracture, allowing the seat back to suddenly recline. | 675,661 |
| 95V-241 | December 13, 1995 | Seat belts (front) | If both the lap-belt and shoulder-belt energy management loops on the front seat belt assemblies release at or near the same time, acceleration forces can cause the buckle release mechanism to activate and allow the buckle to separate from the latch. | 630,099 |
| 95V-242 | December 13, 1995 | Seat belts (front) | These vehicles were built with front seat belt systems with no energy management loops and may not meet the head injury criteria requirements of fmvss no. 208, "occupant crash protection." | 40 |
| 94V-060 | April 5, 1994 | Suspension (front, control arm, lower arm) | Trucks were assembled with the left-hand lower control arm to frame rear nut tightened below the specified torque. Low torque on this nut may allow the attachment bolt to loosed and subsequently fatigue and break. The bolt breakage can cause the left hand control arm to separate from the frame. | 30,148 |
| 93V-216 | December 14, 1993 | Seats | The seats have been assembled without bolts that connect the upper slave hinge to the seat back frame, or without bolts that connect the seat to the seat adjuster. In either case, the vehicles fail to conform to fnvss no. 207, "seating systems." | 1,375 |
| 93V-152 | September 15, 1993 | Service brakes, hydraulic (pedals and linkages) | The brake pedal push rod retainer is missing, mispositioned or not properly seated. | 70,154 |