1995 Lincoln Town Car recalls
The 1995 Lincoln Town Car is affected by 6 safety recall campaigns in NHTSA's records.
At a glance
- Recall campaigns
- 6
- Most recent
- August 3, 2007
Source: NHTSA recall records
Recall campaigns
| Campaign | Reported | Part | Problem | Vehicles |
|---|---|---|---|---|
| 07V-336 | August 3, 2007 | Vehicle speed control | On certain pickup trucks, passenger vehicles, sport utility vehicles, and motor homes chassis, the speed control deactivation switch may, under certain conditions, leak internally and then overheat, smoke, or burn. | 3,600,000 |
| 01V-318 | October 3, 2001 | Air bags (frontal, driver side, inflator module) | Equipment description: passenger vehicles that have had the driver's air bag module replaced after april 5, 2000. The replacement driver's air bag module inflator may have insufficient welds that could prevent proper inflation of the air bag. | 911 |
| 98V-322 | December 16, 1998 | Suspension (front, control arm, lower ball joint) | Vehicle description: certain 1996-1999 ford crown victoria police, fleet, natural gas, and 1996-1999 lincoln town car limousine vehicles that were produced with a lower control arm ball joint containing a one piece bearing; and 1990-1996 ford crown victoria police, fleet, and ngv vehicles and 1990-1996 lincoln town… | 175,000 |
| 96V-135 | July 18, 1996 | Steering (linkages) | The pitman arms were not fully lubricated at the assembly plant. The "ball joint" at the outer end of the pitman arm can become contaminated and corrode. | 72,000 |
| 95V-133 | July 11, 1995 | Service brakes, hydraulic (foundation components, hoses, lines/piping, and fittings) | Improper installation of the rear brake line at the point at which the extended brake line first bends and extends over the left rear wheel area of the frame. If not installed with sufficient clearance, chafing of the brake line can occur in an area adjacent to the rear floor pan. | 692 |
| 95V-063 | March 27, 1995 | Fuel system, gasoline (storage, tank assembly, filler pipe and cap) | The seal material between the fuel filler pipe and fuel tank may not have been fully cured during the molding process which could allow for fuel leakage. | 100,000 |