1991 Chevrolet S10 recalls
The 1991 Chevrolet S10 is affected by 6 safety recall campaigns in NHTSA's records.
At a glance
- Recall campaigns
- 6
- Most recent
- July 19, 1999
Source: NHTSA recall records
Recall campaigns
| Campaign | Reported | Part | Problem | Vehicles |
|---|---|---|---|---|
| 99V-193 | July 19, 1999 | Service brakes, hydraulic (antilock/traction control/electronic limited slip) | Vehicle description: certain 4-wheel drive pickup trucks and sport utility vehicles equipped with ABS (antilock braking system) manufactured from september 1989 through august 1996. Under certain driving conditions the switch which signals the ABS system whether the vehicle is in 2-wheel or 4-wheel drive can… | 1,125,749 |
| 96V-195 | October 8, 1996 | Steering (gear box, shaft sector) | The intermediate steering shaft loosens at the steering shaft to steering gear coupling. With this looseness, the yoke pinch bolt can wear on the splines of the shaft until there is no longer an interference between the splines and the bolt. | 144,598 |
| 93V-008 | January 14, 1993 | Engine and engine cooling (cooling system, fan) | The engine cooling fan blades break as a result of fatigue and/or vehicle induced stress. | 215,052 |
| 91V-108 | June 21, 1991 | Fuel system, gasoline (storage) | Vehicles have been shipped with the fuel tank sender seal out of position. | 102,885 |
| 90V-193 | November 14, 1990 | Suspension (front, control arm, lower arm) | Nuts used to attach lower control arms, rear spring and shackle, and rear shock absorbers do not meet specifications and could "strip". | 237 |
| 90V-107 | June 4, 1990 | Visibility (windshield) | Use of improper primer on metal surfaces of windshield and side window openings could cause low adhesion to the metal surface and would not provide retention required by fmvss 212. | 181 |